Running In The Engine; Preparing The Vehicle For Difficult Operating Conditions; Preparations For Riding On Dry Sand - KTM 150 SX Owner's Manual

PREPARING FOR USE
Guideline
Maximum permissible overall weight
Maximum permissible front axle load
Maximum permissible rear axle load
–
Check the spoke tension. (
Info
The spoke tension must be checked after half an hour of operation.
–
Run the engine in.

Running in the engine

6.2
–
During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
During the first 3 service hours
During the first 5 service hours
–
Avoid fully opening the throttle!

Preparing the vehicle for difficult operating conditions

6.3
Info
Using a motorcycle in difficult conditions can lead to excessive wear of components such as the power train or brakes. For this
reason, it may be necessary to service or replace worn parts before the limit specified in the service schedule is reached.
–
Seal the air filter box.
x
Tip
Seal the air filter box at the edges against dirt.
–
Clean the air filter and air filter box.
Info
Check the air filter approx. every 30 minutes.
–
Additionally secure the rubber grip. (
–
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
Difficult operating conditions are:
–
Riding on dry sand. (
–
Riding on wet sand. (
–
Riding on wet and muddy surfaces. (
–
Riding at high temperatures and low speeds. (
–
Rides at low temperatures or in snow. (

Preparations for riding on dry sand

6.4
p. 71)
( p. 47)
x
p. 56)
p. 16)
p. 17)
p. 18)
p. 18)
p. 19)
–
Check the radiator cap.
Value on the radiator cap
» If the displayed value does not equal the setpoint value:
600872-10
335 kg (739 lb.)
145 kg (320 lb.)
190 kg (419 lb.)
< 70 %
< 100 %
1.8 bar (26 psi)
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
16