Handlebar Position; Adjusting The Handlebar Position - KTM 150 SX Owner's Manual

TUNING THE CHASSIS

Handlebar position

10.14
0 0 A A
0 0 B B

Adjusting the handlebar position

10.15
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
1 1
1 0 0 1
0 0 2 2
2 0 0 2
Guideline
Rebound damping (125/150 SX)
Comfort
Standard
Sport
Rebound damping (250 SX)
Comfort
Standard
Sport
Rebound damping (150 XC USA)
Comfort
Standard
Sport
Rebound damping (250/300 XC)
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
–
Mount protection covers
On the upper triple clamp, there are two holes a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
B00025-11
x
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
14 clicks
12 clicks
10 clicks
14 clicks
12 clicks
10 clicks
14 clicks
12 clicks
10 clicks
14 clicks
12 clicks
10 clicks
.

15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar and lay it

. Remove the handlebar support.

M10
apart.

from the center.

40 Nm Loctite ® 243™
(29.5 lbf ft)
35
.
