Checking The Headlight Setting; Adjusting The Headlight Range; Changing The Speedometer Battery - KTM 125 EXC EU Owner's Manual

15 ELECTRICAL SYSTEM
15.9

Checking the headlight setting

15.10

Adjusting the headlight range

15.11

Changing the speedometer battery

–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by swiveling the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
602764-10
The headlight range may need to be corrected if luggage is carried on the
vehicle.
–
Tighten screw
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
(EXC, XC‑W)
–
Remove screws
–
Pull the speedometer upward out of the holder.
B01565-10
–
Using a coin, turn protection cap
it.
–
Remove speedometer battery
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
101406-10
under the first mark.
B
B
A
p. 103)
.
1
.
1
.
1
2
.
3
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 103)
p. 101)
all the way counterclockwise and remove
p. 128)
103