15
ELECTRICAL SYSTEM
15.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
15.2
Installing the battery
(All 200/250/300 models)
x
Preparatory work
–
Switch off all power consumers and the engine.
–
Remove the seat. (
Main work
–
Disconnect the negative (minus) cable
–
Pull back the plus pole cover
tery.
–
Detach rubber band
–
Lift the battery out.
L01204-10
(All 200/250/300 models)
x
Main work
–
Insert the battery into the battery compartment with the terminals facing to the
front.
Battery (YTX4L-BS)
–
Attach rubber band
–
Attach positive cable
Guideline
Screw, battery terminal
Info
Contact disk
with the claws facing down.
–
Slide positive terminal cover
–
Attach negative cable
Guideline
Screw, battery terminal
101712-10
Info
Contact disk
with the claws facing down.
Finishing work
–
Mount the seat. (
p. 69)
of the battery.
1
and disconnect the positive (plus) cable of the bat-
2
at the bottom.
3
.
1
.
2
M5
must be mounted between screw
A
over the positive terminal.
6
.
3
M5
must be mounted between screw
A
p. 69)
98
2.5 Nm
(1.84 lbf ft)
and cable socket
4
5
2.5 Nm
(1.84 lbf ft)
and cable socket
4
5