Yamaha YZ250(P)/LC Owner's Service Manual page 454

HANDLEBAR
10. Install:
9
Bolt (grip cap) 1
w
9
Install the grip cap so that the gaps
b b between the bolt (grip cap) and brake
lever 2 2 are equal. If you make a mistake in
the grip cap installation position, the brake
lever may contact the grip cap, resulting in
poor brake performance.
9
After tightening the bolts, check that the
throttle grip 3 3 moves smoothly. If it does
not, retighten the bolts for adjustment.
11. Install:
9
"ENGINE STOP" button 1
9
Clutch lever holder 2
9
Bolt (clutch lever holder) 3
9
Clamp 4
NOTE:
9
The "ENGINE STOP" button, clutch lever hold-
er and clamp should be installed according to
the dimensions shown.
9
Pass the "ENGINE STOP" button lead in the
middle of the clutch holder.
12. Install:
9
Clutch cable 1
NOTE:
Apply the lithium soap base grease on the clutch
cable end.
13. Adjust:
9
Clutch lever free play
Refer to "CLUTCH ADJUSTMENT" section in
the CHAPTER 3.
5-45
CHAS
4 Nm (0.4 m•kg, 2.9 ft•lb)
a a and
4 Nm (0.4 m•kg, 2.9 ft•lb)