Unpacking And Removing A Workgroup System Tower From A Pallet; Open The Top Of The Cardboard Box - HP Cluster Platform Introduction v2010 Installation Manual

3 Unpacking and Removing a Workgroup System Tower
from a Pallet
This chapter describes how to unpack and remove the Workgroup System Tower from a pallet.
To unpack and remove the Workgroup System Tower from a pallet, follow these steps:
1. Move the pallet to the installation location and leave several feet of space to move around
the pallet.
Note:
Carton graphics provide the instructions on how to unpack the Workgroup System Tower
and to open the top of the box first.
2. Open the top of the cardboard box, as shown by callout 1 in
Figure 3-1 Open the Top of the Cardboard Box
1
3. Remove the two boxes containing the security bezel, power cords, and other accessories, as
shown by callout 2 in
4. Remove the cushions from the top of the unit, as shown by callout 3 in
cardboard box, as shown by callout 1 in
2 2
3
Figure 3-1.
Figure
Figure 3-1.
3
3-2.
Figure 3-1 and the
23