Configuring Hosts For Encryption Targets - Brocade Communications Systems Brocade 8/12c Administrator's Manual

2

Configuring hosts for encryption targets

Configuring hosts for encryption targets

Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.
NOTE
Hosts are normally selected as part of the Configure Storage Encryption wizard but you can also edit
hosts later using the Encryption Target Hosts dialog box.
1. Select Configure > Encryption from the menu task bar.
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
3. Select a Target storage device from the list, then click Hosts.
FIGURE 51
4. Select one or more hosts in a fabric, then move them to the Selected Hosts table using the
64
The Encryption Center dialog box displays.
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar, or right-click a group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays.
The Encryption Target Hosts dialog box displays. This dialog box lists configured hosts in a
fabric.
Encryption Target Hosts dialog box
right arrow, or manually enter world wide names in the Port WWN and Node WWN text boxes if
the hosts are not included in the list. You must fill in both the Port WWN and the Node WWN.
Click Add to move the host to the Selected Hosts list.
Fabric OS Encryption Administrator's Guide
53-1002159-03