Errors Related To Adding A Switch To A New Group - Brocade Communications Systems Brocade 8/12c Administrator's Manual

6
Management application encryption wizard troubleshooting

Errors related to adding a switch to a new group

Table 12
and describes how to troubleshoot them.
TABLE 12 Error recovery instructions for adding a switch to a new group
Configuration task
Initialize the switch
Create encryption group on the
switch
Register one or more key vaults
Enable the encryption engines
232
lists configuration task errors you might encounter while adding a switch to a new group,
Error description
Unable to initialize the switch due to an
error response from the switch.
The switch was not properly initialized
and was aborted because it is
unavailable.
A failure occurred while attempting to
create a new encryption group on the
switch.
A failure occurred while attempting to
register one or more key vaults for a
group on the switch.
A failure occurred while attempting to
enable encryption engines on the
switch.
Instructions
Diagnose the problem using standard switch CLI
commands.
Re-run the Configure Switch Encryption wizard for the
switch.
1 Click the Refresh button on the Configure Switch
Encryption dialog box to synchronize the data and
the database.
2 Re-run the Configure Switch Encryption wizard for
the switch.
1 Remove the switch from the group using the Group
Members tab on the Encryption Group Properties
dialog box.
2 Re-run the Configure Switch Encryption wizard for
the switch.
Manual Option:
1 Launch the Encryption Group Properties dialog box
and click the General tab.
2 From the General dialog box, click Load from File to
install key vault certificates, and then click OK to
save the information on to the switch.
3 Follow the Key Vault instructions.
1 Remove the switch from the group using the Group
Members tab on the Encryption Group Properties
dialog box.
2 Re-run the Configure Switch Encryption wizard for
the switch.
Manual Option:
1 Launch the Switch Encryption Properties dialog box.
2 Save the switch's public key certificate to a file using
the Switch Encryption Properties dialog box.
3 Follow the Key Vault instructions for the key vault.
Fabric OS Encryption Administrator's Guide
53-1002159-03