Brocade Communications Systems Brocade 8/12c Administrator's Manual page 230

6
Encryption group and HA cluster maintenance
1. Invoke the cryptocfg
2. Commit the transaction. If failback mode is set to auto, the target (T2) which failed over earlier
3. Invoke the cryptocfg
4. Invoke the cryptocfg
5. After the transaction is committed, remove the failed encryption engine from the encryption
210
replace -haclustermember command on the group leader to replace the
--
failed encryption engine (EE2) with another encryption engine (EE3). This operation effectively
removes the failed encryption engine (EE2) from the HA cluster and adds the replacement
encryption engine (EE3) to the HA cluster. The target associations (T2) from the failed
encryption engine (EE2) are transferred to the replacement encryption engine (EE3).
to EE1 automatically fails back to the replaced encryption engine (EE3).
reclaimWWN -EE command on the group leader followed by WWN of the
--
DCX/DCX-4S and the slot number of the encryption engine to be removed.
commit command to sync the configuration in the encryption group.
--
group.
FIGURE 110
Replacing a failed encryption engine in an HA cluster
Fabric OS Encryption Administrator's Guide
53-1002159-03