HP 9000 Superdome SX2000 Installation Manual page 37

1. Using a T-20 driver, loosen the captive screw at the top center of the front EMI panel
(Figure 32).
Figure 32 Removing Front EMI Panel Screw
2. Use the handle provided to remove the EMI panel and set it aside.
When in position, the EMI panels (front and back) are tightly in place. Removing them takes
controlled but firm exertion.
3. Loosen the captive screw at the lower center of the back EMI panel
Figure 33 Removing the Back EMI Panel
4. Use the handle provided to gently remove the EMI panel and set it aside.
(Figure 33 (page 37)).
Setting Up the System 37