HP 9000 Superdome SX2000 Installation Manual page 10

Tools Required
The following tools are required to unpack and install the system:
Standard hand tools, such as a adjustable-end wrench
ESD grounding strap
Digital voltmeter capable of reading ac and dc voltages
1/2-inch socket wrench
9/16-inch wrench
#2 Phillips screwdriver
Flathead screwdriver
Wire cutters or utility knife
Safety goggles or glasses
T- 1 0, T- 1 5, T-20, T-25, and T-30 Torx drivers
9-pin to 25-pin serial cable (HP part number 24542G)
9-pin to 9-pin null modem cable
Unpacking the Cabinet
WARNING!
HP recommends removing the cardboard shipping container before moving the cabinet into the
computer room.
NOTE: If unpacking the cabinet in the computer room, be sure to position it so that it can be
moved into its final position easily. Notice that the front of the cabinet
the label showing how to align the ramps.
To unpack the cabinet, follow these steps:
10 Installing the System
Use three people to unpack the cabinet safely.
(Figure 3) is the side with