HP 9000 Superdome SX2000 Installation Manual page 29

Figure 23 Installing the Rear Blower Bezel
3. Align the bezel over the nuts that are attached to the bracket at the rear of the cabinet.
4. Using a T-20 driver, tighten the two captive screws on the lower flange of the bezel.
NOTE:
5. Close the cabinet rear door.
Installing the Front Blower Bezel
The front blower bezel is a cosmetic cover for the blowers and is located above the front door. To
install the front blower bezel, follow these steps:
1. Open the front door.
NOTE:
2. Position the bezel over the blower housing frame, hooking the lip of the bezel onto the cross
support of the blower housing
Tighten the screws securely to prevent them from interfering with the door.
The latch is located on the right side of the front door.
(Figure 24 (page 30)).
Setting Up the System 29