Options; Access Levels - HP ProCurve 6120G/XG Manual

Options

You can configure:
■
■
C a u t i o n
Configuring Authorized IP Managers does not protect access to the switch
through a modem or direct connection to the Console (RS-232) port. Also, if
an unauthorized station "spoofs" an authorized IP address, it can gain man­
agement access to the switch even though a duplicate IP address condition
exists. For these reasons, you should enhance your network's security by
keeping physical access to the switch restricted to authorized personnel, using
the username/password and other security features available in the switch,
and preventing unauthorized access to data on your management stations.

Access Levels

N o t e
The Authorized IP Manager feature can assign an access level to stations using
Telnet, SNMPv1, or SNMPv2c for switch access. The access level the switch
allows for authorized stations using SSH, SNMPv3, or the web browser
interface is determined by the access application itself, and not by the Autho­
rized IP Manager feature.
For each authorized manager address using Telnet, SNMPv1, or SNMPv2c, you
can configure either of these access levels:
■
■
Up to 10 authorized manager addresses, where each address applies to
either a single management station or a group of stations
Manager or Operator access privileges (for Telnet, SNMPv1, and
SNMPv2c access only)
Manager: Enables full access to all web browser and console interface
screens for viewing, configuration, and all other operations available in
these interfaces.
Operator: Allows read-only access from the web browser and console
interfaces. (This is the same access that is allowed by the switch's opera­
tor-level password feature.)
Using Authorized IP Managers

Options

14-3