Configuring Traffic/Security Filters - HP ProCurve 6120G/XG Manual

ProCurve(config)# show filter source-port
Traffic/Security Filters
Filter Name
-------------------- + -------------------- + --------------------------
web-only
accounting
no-incoming-web
ProCurve(config)#
Figure 11-12. Named Source-Port Filters Managing Traffic

Configuring Traffic/Security Filters

Use this procedure to specify the type of filters to use on the switch and
whether to forward or drop filtered packets for each filter you specify.
1. Select the static filter type(s).
2. For inbound traffic matching the filter type, determine the filter action
3. Configure the filter.
4. Use show filter (page 11-20) to check the filter listing to verify that you
| Port List
| 2-6,9,14-26
| 7-8,10-13
| 1
you want for each outbound (destination) port on the switch (forward or
drop). The default action for a new filter is to forward traffic of the
specified type to all outbound ports.
have configured correct action for the desired outbound ports.
Traffic/Security Filters and Monitors
Configuring Traffic/Security Filters
| Action
| drop 2-26
| drop 1-6,9,14-26
| drop 7-8,10-13
11-15