Oneida Air Systems AXD001004 Owner's Manual page 8

VI. Assembly Instructions for Ultimate Dust Deputy
1. With a Phillips head screwdriver, attach
the two rubber latches, one on either side of
the dust collection box using the (4) 10 x 32
x 1" machine screws included
in the hardware pack. Make sure
that the handle of the latch curves
downward when attached or when
in the up position it points out.
2. Take the provided length of gasket, peel the
Gasket
3. Put Gasket on box top making sure gasket holes
4. With a Phillips head screwdriver, attach
7
protective backing off of the gasket and carefully
place the gasket fl at around the underside of the
box top as shown in the picture.
It is very important that there are no gaps in the
gasket where the ends meet. Make sure they
are butted together!
line up with bolt holes in top.
the Cyclone with the (6) provided 1/4"x 20
x 3/4" bolts. Tighten in a star pattern as
shown. Do NOT over tighten.
Point inlet at
either latch.
Star Bolt Pattern
Dust Deputy Owner's Manual © 2010
IX. Adding Cyclones to Improve Performance
Top View
This arrangement may be useful
for very fi ne dust situations.
Attach in Series
Increases particle effi ciency.
Top View
Your arrangement is
only limited by your
imagination!
Attach in Parallel
Same particle effi ciency but
increases CFM.
Top View
Multiple Vacuums
More Airfl ow to Big Tools.
More CFM.
Dust Deputy Owner's Manual © 2010
200 CFM
100 CFM 100 CFM
- Table Saw
- Jointer
- Planer
2 or More
12