Oneida Air Systems AXD001004 Owner's Manual page 10

VII. Installing the Dust Bagger
Attach vacuum hose elbow
with valve to vacuum as
shown in Fig. 5. Push in-
cluded plastic tubing into 1/4"
tubing elbow. (Fig. 1)
Fig.1
Push other end of tubing into
1/4" tubing valve. (Fig. 2)
Tubing can be cut to desired
length.
To remove tubing from valve,
you must push end of valve
in to release the grip. See ar-
row in Fig. 2. Ensure valve is
open when using bags. Valve
Fig.2
shown in open position.
Place included fi lter into han-
dle space of top valve inside
of box. (Fig. 3) This prevents
bag from being sucked into
valve and prevents dust from
entering valve if used without
bag.
Fig.3
Place bag into box, tucking
Fig.4
into corners and folding top of
bag over top of box. (Fig. 4)
9
Fig.5
Place top on box and latch down,
attach your hoses to the Dust
Deputy inlet and outlet and you're
ready to go! (Fig.5)
Fig.6
If you want to run the Dust Deputy
without the bag, you must shut the
valve by turning the valve handle
90 degrees. The system must be
air-tight to operate properly. Fig.6
shows valve in open position.
Note: Before resuming using
plastic bags you must vacuum
off the foam fi lter (Fig. 3) so air
fl ow is not restricted.
Dust Deputy Owner's Manual © 2010
VIII. Possible Ways to Attach Dust Deputy Deluxe to Shop Vacuums
Dust Deputy Owner's Manual © 2010
You may want to attach your Dust Deputy
to your shop vacuum for mobility, conve-
nience or stability. There is no defi nitive
way to attach the Dust Deputy to a shop
vacuum. It will vary with vacuum type and
intended use. These are just a few exam-
ples of possible ways it may be done.
Cut the provided foam block in half. Drill
two 1/4" holes through bucket, blocks
and vacuum as shown, then using
provided long bolts, washers and nuts,
attach bucket to vac.
Use the foam blocks as spacers
between the vac and bucket then put
the assembled Dust Deputy into the at-
tached bucket to hold it securely to the
vacuum. Attach the appropriate hoses
and you're ready to go.
Some vacuums may only require one foam
block to attach the bucket. This may be
determined by vacuum body shape.
Cut the provided foam block to size. Drill two
1/4" holes through bucket, blocks and vacuum
as shown, then using provided long bolts,
washers and nuts, attach bucket to vac.
Use the foam block as upper spacer between
the vac and bucket then put the assembled
Dust Deputy into the attached bucket to hold
it securely to the vacuum. Attach the appropri-
ate hoses and you're ready to go.
The mounting is only limited by your
imagination.
To prevent tipping problems,
please see pg. 13 in this manual.
10