Oneida Air Systems AXD001004 Owner's Manual page 6

IV. Assembly Instructions for D.I.Y. Dust Deputy
The Dust Deputy is made of static dissipating plastic.
Hose to
These are the minimum parts you will need to acquire to use the Dust Deputy:
Vacuum
Hose
- Shop Vacuum
to
Tools
- Dust drum or container that will withstand the vacuum pressure (We
recommend at least a 90 mil side thickness otherwise the container may
collapse when in use.) and has a lid that can be tightly sealed. (e.g.- 5 gal.
plastic drywall bucket) Drum must be 100% air tight.
Any air leak in lid or drum will affect separation performance.
For wood dust use a smaller container (up to 10 gal.)
To reduce the chance of fi re hazard, empty container after each use.
- 2" - 2 1/4" dia. Vacuum Hose to go between the Dust Deputy outlet and
your Shop Vacuum.
Make sure larger
diameter hoses are
pushed up so they fi t - Vacuum Hose to attach to Dust Deputy inlet and your tools.
tightly over the inlet
- (6) 1/4" x 1" bolts with nuts and washers.
- Any suitable sealant (e.g.- Silicone) to use between the cyclone base
fl ange and the top of your dust container. Any air leak between the
cyclone and lid will affect separation performance. You should also seal
the inlet and outlet hose connections.
How to Make Template for Drum Lid and Assemble Dust Deputy
1. Place cyclone base in center of drum lid.
2. With pen, trace around base and bolt holes.
3. Connect opposite bolt holes with lines as shown
above to fi nd center.
4. Draw 3" dia. circle for drum inlet. Carefully cut out
3" hole in lid.
5. Use 5/16" drill bit to drill bolt holes.
6. Spread even layer of sealant between center hole and bolt
holes on drum lid. (See above diagram.) You must have a
complete seal between cyclone and drum lid or performance will be affected.
7. Put bolts through washer and cyclone base then fasten with nuts under drum lid.
8. Lid must completely seal to drum. Any air leaks will affect performance.
9. Attach one hose from top cyclone outlet to shop vacuum and the other hose from side cyclone
inlet to your tools or use hose by itself to pick up waste.
5
XI. Super Dust Deputy
Turn Any Single Stage Collector Into A Super Cyclonic Dust Collector!
1. Add A Super Dust Deputy Cyclone.
Benefi ts & Features:
Sealant
Dust Deputy Owner's Manual © 2010 Dust Deputy Owner's Manual © 2010
Dust Collector, Dust
Drum and Flex Hose
Not Included.
Turn your ineffi cient single stage or two stage collec-
tor into a high effi ciency cyclonic collector using your
existing blower. Retrofi ts to single stage 1/2hp to 3hp
dust collectors.
High effi ciency cyclone separates 98% of wood waste
before the fi lter. Filter clogging no longer reduces air
fl ow.
Compact footprint. Simple installation.
Reduced fi lter maintenance and no dusty bags to empty.
Height approx. 23" / Inlet Diameter: 5" O.D.
System
Outlet Diameter: 6"
Dimensions
Powder Coated Paint Finish Over Steel
Super Dust Deputy Cyclone
Included
5" Spiral Adapter
Use Your
Fan Blower.
23"
Part #
AXD002030
14