Cooling Fan; Door Assemblies; Ribbon Cable Assembly - GE Profile PT925 Technical Service Manual

Cooling Fan

The cooling fan is located in a recess in the back of
the oven. It is necessary to remove the oven from
the installation to access the cooling fan.
The fan will begin to operate when the oven is in
any cooking mode. The fan may continue to operate
even after the oven is turned off.
To remove the cooling fan:
1. Remove the main rear access panel. (See
.)
Access Panels
2. Disconnect the wire harness and the ground
wire from the cooling fan.
Disconnect
Cooling Fan
3. Remove the four 1/4-in. hex-head screws (2
on each side) that hold the cooling fan to the
control compartment.
4. Carefully grasp the assembly and tilt the unit
back, up, and out of the oven frame.

Ribbon Cable Assembly

To remove the ribbon cable assembly:
1. Open or remove the lower door.
2. Release the ribbon cable assembly from the
door. (See
3. Remove the secondary rear access panel. (See
Rear Access Panels.
4. Disconnect the back of the ribbon cable from
Rear
the mating connector.
5. Remove the 4 screws and nuts from the front
end of the ribbon cable housing.
6. Remove the ribbon cable by sliding it out of the
ribbon cable sleeve.
Note: When installing the new ribbon cable, ensure
that the new cable is positioned between the wings
of the ribbon guide located between the oven
cavities.
– 41 –
.)

Door Assemblies

)
Disconnect