GE Profile PT925 Technical Service Manual page 30

To replace the lower inner door assembly:
1. Remove the outer door assembly. (See
.)
Assemblies
2. Remove the four T15 Torx screws (2 on each
side) that attach each door hinge to the inner
door. Carefully turn the door over and remove
both door hinges.
3. Remove the six 1/4-in. hex-head screws that
hold the insulation retainer to the inner door.
Remove the insulation retainer.
4. Remove the insulation and the inner glass
assembly from the inner door.
Inner Glass Assembly
To remove the upper outer door assembly:
1. Remove the upper door. (See
Door
2. Place the inner door assembly, gasket side up,
on a protective surface.
3. Remove the two T15 Torx screws from the
bottom of the outer door assembly.
4. Remove the two T15 Torx screws (1 on each
side) from the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
5. Separate the inner door assembly from the
outer door assembly.
6. Remove the four 1/4-in. hex-head screws and
brackets that hold the door handle to the outer
door assembly.
Door Shown with Inner Door Assembly Removed
Caution: Care must be taken if reinstalling the door
handle. Overtightening the screws can damage the
handle. Hand-tighten the screws and make sure the
handle fits snugly to the door panel. (Do not use an
electric driver.)
– 30 –
Door Assemblies
1 of 2
Outer Door Assembly
(Continued next page)
.)