Viewing Lamp Usage And Other Information - Epson PowerLite 260D User Manual

note
The lamp usage timer doesn't
register until you've used the
lamp for at least 10 hours.
note
You can make changes to
many of the signal settings on
the Signal menu. See page 56
for details.
Fine-tuning the Projector
64
Viewing Lamp Usage and Other
Information
Use the Info menu to view information about the display settings, and
the amount of time the lamp and air filter have been used.
1. Press the button and select the
Menu
displaying the following information:
■
Lamp Hours
Displays the number of hours the lamp has been used. The
life span of the lamp ranges from about 2900 hours in
brightness mode to about 3900 hours in
mode. If the number shown is close to 2900 or the
information is displayed in red, make sure you have a spare
lamp handy. See page 76 to replace the lamp.
■
Air Filter
Displays the number of hours the air filter has been used.
■
Source
Displays the input source currently being projected.
■ Input Signal
Displays the input signal setting.
(computer, RGB, and Component signal)
■ Resolution
Displays the input resolution.
(CVBS signal and Y/C signal)
■ Signal
Displays the signal format.
■ Refresh Rate
Displays the refresh rate.
(computer, RGB, and Component signal)
■
Sync Info
Provides information that may be needed by the service
technician.
■
Status
Displays information about projector problems. This
information may be needed if service is required.
2. When you're finished, press
Info
(computer, RGB, and Component signal)
(computer, RGB, and Component signal)
or
Esc Menu
menu. You see a screen
High
brightness
Low
.