Solving Problems
92
Solving Password Problems
You have forgotten the password.
■
Write down the request code that appears in the Password Protect
Release screen and contact Epson. See page 94.
■
If you turned on the password protect feature before setting the
password and no password was set before, try using the default
password:
.
0000
The remote control is not available.
You must have the remote control to enter the password. If necessary,
you can purchase a replacement remote control from Epson. See
page 94 for details.
Solving Problems With the Remote
Control
The projector doesn't respond to remote control commands.
■
Make sure you are within 6 m of the projector, and within range
of the projector's front or back sensor (approximately 30° to the
left or right and 15° above or below).
If a button on the remote control is held for more than
■
30 seconds, the remote enters sleep mode. Press another button
for normal operation.
■
The remote control batteries may not be installed correctly or may
be low on power. Replace the batteries as described on page 48.
■
Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector's infrared
receivers.