Setting A Password; Turning On The Password And User's Logo - Epson PowerLite 260D User Manual

note
If a password has already
been set, you see the
Password Protect Release
screen. See "Starting the
Projector With a Password"
on page 69.
Numeric buttons on
remote control
Fine-tuning the Projector
68

Setting a Password

1. Press the button on the remote control for about
Freeze
7 seconds until you see the Password Protect menu:
2. Select and press
Password
the password?
3. Select and press
Yes
4. Enter a 4-digit number using the numeric buttons on the remote
control, as shown.
The password will be displayed as
digit, a confirmation screen appears. Enter the password again.
You see the message
5. After you finish setting the password, press the
return to the Password Protect menu.
Make a note of the password and keep it in a safe place in case you
forget it.

Turning On the Password and User's Logo

1. Press the button on the remote control for about
Freeze
7 seconds until you see the Password Protect menu.
2. To enable the password, select
. Select then press
Enter ON
3. To enable your screen logo, select
. Select and press
Enter ON
. You see the message
Enter
.
Enter
. After you enter the last
****
.
Password accepted
Power On Protect
.
Esc
User's Logo Protect
.
Enter
Change
button to
Esc
and press
and press