Connecting A Y/C Signal Source - Epson PowerLite 260D User Manual

Connecting a Y/C Signal Source

If your image source has an Y/C signal jack, you can use it to project a
higher quality image. You'll need an Y/C signal cable, which is usually
provided with your image source, or you can purchase one from an
Epson Authorized Reseller (part number ELPSV01). To find the
reseller nearest you, see page 94.
Before starting, make sure the projector and your image source are
turned off.
1. Insert one end of the Y/C signal cable into the projector's port
shown below, and the other end into the Y/C signal output port
of your image source.
PowerLite 260d
Connect
Y/C signal
cable
PowerLite 280d
2. To play sound through the projector, follow the instructions
beginning on page 28.
If you don't need to make any other connections, you can plug in
your projector and turn it on. See page 31 for instructions.
If more than one device is connected to the projector, select the
correct source after projection starts by pressing the
button on the projector or remote control. See page 33.
Source Search
Setting Up the Projector
25