Epson PowerLite 260D User Manual page 89

The signal may be split between the computer and the projector.
■
If you notice a decline in the projected image quality when the
image is displayed simultaneously on your laptop computer and
the projector, turn off the laptop's LCD display.
If you're projecting from a CVBS signal or Y/C signal source,
■
check the signal setting in the Signal menu. In most cases, leave it
set at . If you're using a 60-Hz image source, change this
Auto
setting to a option. See page 58 for details.
60
Make sure the cables are securely connected at both ends.
■
■ If you're projecting from a computer, press the
button on the remote control or the
projector to adjust tracking and sync automatically. If that doesn't
work, try adjusting the
menu. See page 57.
The image is blurry.
Adjust the focus using the focus ring. See page 35
■
(PowerLite 260d) or page 37 (PowerLite 280d).
There may be dirt or smears on the lens cover glass. Clean the
■
glass as described on page 73.
Make sure the lens cover glass is not fogged by condensation. You
■
may need to wait before using the projector after moving it from a
cold environment.
Make sure the projection distance is within the range described on
■
page 15.
Adjust the
■ Sharpness
You should be able to see the effect on the screen immediately.
The keystone correction setting may be too extreme. Decrease the
■
projection angle and the amount of keystone correction. See
page 39.
button on the
Enter
and settings in the Signal
Sync Tracking
setting on the Image menu (see page 55).
Enter/Auto
Solving Problems
89