Configuring The Collaboration Function - 3Com 4500G Family Configuration Manual

Configuration prerequisites
Enable the DLSw function on the peer device before DLSw test.
Configuring a DLSw test
Follow these steps to configure a DLSw test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as
DLSw and enter test type view
Configure the destination
address for a test operation
Configure the source IP
address of a probe request in a
test operation
Configure common optional
parameters

Configuring the Collaboration Function

Collaboration is implemented by establishing collaboration objects to monitor the detection results of
the current test group. If the number of consecutive probe failures reaches the threshold, the configured
action is triggered.
Follow these steps to configure the collaboration function:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the
test group
Create a collaboration
object
Exit to system view
Use the command...
system-view
nqa entry admin-name
operation-tag
type dlsw
destination ip ip-address
source ip ip-address
See Configuring Optional
Parameters Common to an
NQA Test Group
Use the command...
system-view
nqa entry admin-name operation-tag
type { dhcp | dlsw | ftp | http |
icmp-echo | snmp | tcp | udp-echo }
reaction item-num checked-element
probe-fail threshold-type
consecutive occurrences [ action-type
{ none | trigger-only } ]
quit
1-18
Remarks
—
—
Required
Required
By default, no destination IP
address is configured for a test
operation.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
Remarks
—
—
The collaboration function
is not supported in UDP
jitter or voice tests.
Required
Not created by default.
—