Configuring A Tcp Test - 3Com 4500G Family Configuration Manual

To do...
Configure the destination
address for a test operation
Specify the source port number
for a probe request in a test
operation
Configure the source IP
address of a probe request in a
test operation
Configure common optional
parameters

Configuring a TCP Test

A TCP test is used to test the TCP connection between the client and the specified port on the NQA
server and the setup time for the connection, thus judge the availability and performance of the services
provided on the specified port on the server.
Configuration prerequisites
A TCP test requires cooperation between the NQA server and the NQA client. The TCP listening
function needs to be configured on the NQA server before the TCP test. For the configuration of the
TCP listening function, see
Configuring a TCP test
Follow these steps to configure a TCP test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as TCP
and enter test type view
Configure the destination
address for a test operation
Use the command...
destination ip ip-address
source port port-number
source ip ip-address
See Configuring Optional
Parameters Common to an
NQA Test Group
Configuring the NQA Server.
Use the command...
system-view
nqa entry admin-name
operation-tag
type tcp
destination ip ip-address
1-13
Remarks
Required
By default, no destination IP
address is configured for a test
operation.
Optional
By default, no source port number
is specified.
Optional
By default, no source IP address
is specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Optional
Remarks
—
—
Required
Required
By default, no destination IP
address is configured for a test
operation.
The destination address must be the
IP address of the listening service
configured on the NQA server.