INSTALLATION
5
SPECIFICATIONS
Width: 22.25"
Height: 43.125"
Depth: 26"
Weight: 277 lbs.
Flue size: 3" or 4"
Hopper Capacity: Up to 80 lbs.
(This can vary widely depending on pellet size, length, and
diameter)
EPA status: exempt
Burn time: 1 lb. to 4.7 lbs. per hour
BTU range: 8,200 to 40,000
Approved installations: mobile home, conventional, and alcove
(shown here). See page 7 for additional installations
PREPARATION
Factory packaging must be removed, and some minor assembly
work is required prior to installation. Access to the rear of the
stove is necessary.
NOTE: Normally, your dealer will perform these functions.
FOR INSTRUCTIONS REGARDING CONTROL PANEL
INSTALLATION PLEASE SEE PAGE 9.
CLEARANCES
The Solstice has been tested and listed for installation in
residential and mobile homes.
FLOOR PROTECTION: The stove must be placed on a
continuous (grouted joints) noncombustible material such as
ceramic tile, cement board, brick, 3/8" millboard or equivalent, or
other approved or listed material suited for floor protection.
THE MATERIAL(S) USED MUST HAVE, OR COMBINE TO
HAVE, A MINIMUM INSULATIVE RATING OF 'R1'.
NOTE: ceramic tile, or any tile, requires a continuous sheet
beneath to prevent the possibility of embers falling through to
the combustible floor if cracks or separation should occur in the
finished surface, this would include floor protection for Built-in
raised hearths. Check local codes for approved alternatives.
Clearances are measured from the sides, back and face (door
opening) or stove body
DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES
IN THE INSTALLATION OF THIS UNIT.
INSTALL VENT WITH CLEARANCES SPECIFIED BY THE
VENT MANUFACTURER.