Download
Share
Print this page
Breckwell SP 6000 Owner's Manual
  1. Manuals
  2. Brands
  3. Breckwell Manuals
  4. Stove
  5. SP6000
  6. Owner's manual

Breckwell SP 6000 Owner's Manual

Multi-fuel stove
Hide thumbs Also See for SP 6000:

Advertisement

Quick Links

Download this manual See also: Installation & Operator's Manual
•
•
•
•
©

Advertisement

loading

Related Manuals for Breckwell SP 6000

Summary of Contents for Breckwell SP 6000

  • Page 1 • • • • ©...
  • Page 3 SP 6000 Multi-Fuel Stove Freestanding...
  • Page 6 ° ° ERAMIC TILE OR ANY OTHER TILE CONTINUOUS SHEET OF NON COMBUSTIBLE MATERIAL BENEATH TO PREVENT THE POSSIBILITY OF EMBERS FALLING THROUGH TO THE COMBUSTIBLE FLOOR IF CRACKS OR SEPARATION SHOULD OCCUR IN THE FINISHED SURFACE HIS INCLUDES FLOOR PROTECTION FOR BUILT IN RAISED HEARTHS HECK LOCAL CODES FOR APPROVED...
  • Page 7 OMBUSTION AIR SUPPLY IS REQUIRED FOR ALL MOBILE HOME INSTALLATIONS ALSO IN CONVENTIONAL HOME INSTALLATIONS IF THE UNIT IS BEING INSTALLED IN A BASEMENT SMALL ROOM OR EXTREMELY WELL INSULATED OR AIRTIGHT HOMES...
  • Page 9 ’ OLLOW ENT CHIMNEY MANUFACTURER S INSTRUCTIONS...
  • Page 10 ’ OLLOW ENT CHIMNEY MANUFACTURER INSTRUCTIONS...
  • Page 11 ’ OLLOW ENT CHIMNEY MANUFACTURER S INSTRUCTIONS...
  • Page 12 HE USE OF OTHER THAN WOOD PELLETS CONFORMING TO THE ELLET UELS NSTITUTE STANDARDS OR WHOLE SHELLED CORN IS NOT APPROVED AND MAY RESULT IN THE UNSAFE OPERATION OF THE STOVE AND...
  • Page 16 CAUTION: AVOID OVERFIRING YOUR STOVE!
  • Page 18 F THE POWER IS INTERRUPTED TO THE STOVE AND THE FIRE EXTINGUISHES THE STOVE WILL REQUIRE MANUAL “ ” RELIGHTING HIGH LEVEL MUST ALSO BE RESET...
  • Page 19 NSPECT BURN POT PERIODICALLY TO SEE THAT HOLES HAVE NOT BECOME PLUGGED IF SO CLEAN THEM THOROUGHLY HIS UNIT IS NOT DESIGNED TO HANDLE HOT ASHES...

  • Page 20: When Cleaning

    HEN CLEANING BE CAREFUL NOT TO DISLODGE ANY BALANCING CLIPS ON THE CONVECTION BLOWER OR TO BEND THE FAN BLADES BE SURE TO HAVE A REPLACEMENT GASKET AVAILABLE ESPECIALLY WHEN CLEANING THE COMBUSTION BLOWER...
  • Page 24 Inspect all vent pipe connections. Make sure they are sealed with RTV silicone that has a temperature rating on 500 degree F or higher. Also, seal joints with UL-181-AP foil tape. Also, make sure the square to round adapter piece on the combustion blower has been properly sealed with the same RTV.
  • Page 25 • • •...
  • Page 26 Clean any dust off of the windings and fan blades. If oiling the blower does not help, the blower may be bad. SMOKE SMELL OR SOOT BUILD-UP...