Table of Contents
Advertisement
ELECTRICAL SPECIFICATIONS
This appliance, when installed, must be electrically grounded
in accordance with local codes, or in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70,
or the Canadian Electrical Code, CSA C22.1.
WIRING REQUIREMENTS
The Ignition Module requires 120V of electricity and/or
batteries to operate.
Using the battery back-up will operate the burner only.
Optional fan component will not function on battery back
up power.
WARNING:
DO NOT USE THIS UNIT IF ANY PART HAS BEEN UNDER
WATER. IMMEDIATELY CALL A QUALIFIED SERVICE
TECHNICIAN TO INSPECT THIS APPLIANCE AND TO
REPLACE ANY PART OF THE CONTROL SYSTEM AND ANY
GAS CONTROL WHICH HAS BEEN UNDER WATER.
FLAME
SENSOR
IGNITER
BATTERY
PACK
885 PROFLAME
PILOT
BURNER
SW1 BUTTON (RED)
© 2021 Breckwell Hearth
PILOT
MAIN ON/OFF
SWITCH
42
ELECTRICAL INSTALLATION
WARNING:
ELECTRICAL
GROUNDING
APPLIANCE IS EQUIPPED WITH A THREE-PRONG
(GROUNDING) PLUG FOR YOUR PROTECTION AGAINST
SHOCK HAZARD AND SHOULD BE PLUGGED DIRECTLY
INTO
A
PROPERLY
RECEPTACLE. DO NOT CUT OR REMOVE THE GROUNDING
PRONG FROM THIS PLUG.
WARNING:
ELECTRICAL
CONNECTIONS
PERFORMED BY A QUALIFIED, LICENSED ELECTRICIAN.
MAIN POWER MUST BE OFF WHEN CONNECTING TO
MAIN ELECTRICAL POWER SUPPLY OR PERFORMING
SERVICE. ALL WIRING SHALL BE IN COMPLIANCE WITH
ALL LOCAL, CITY AND STATE CODES. THE APPLIANCE,
WHEN INSTALLED, MUST BE ELECTRICALLY GROUNDED IN
ACCORDANCE WITH LOCAL CODES OR IN THE ABSENCE
OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL
CODE ANSI/NFPA 70 (LATEST EDITION) AND CANADIAN
ELECTRICAL CODE, CSA C22.1.
INSTRUCTIONS:
GROUNDED
THREE-PRONG
SHOULD
ONLY
GND
N
L
FEMALE
END
GND
(OPTIONAL)
VARIABLE
SPEED FANS
THIS
BE
Advertisement
Table of Contents
