Installation; Specifications; Approved Installations; Preparation - Breckwell SP6000 Owner's Manual

INSTALLATION

S
PECIFICATIONS
Width: 27 ¼"
Height: 35 ½"
Depth: 28 ⅝"
Weight: 225 Pounds
Flue Size: 3" or 4 "
Hopper Capacity: 90 Pounds (Corn)
(This will vary depending on fuel)
EPA Status: Exempt
Maximum BTU Input: 50,000 BTU with whole corn
A I
PPROVED NSTALLATIONS
Alcove, Conventional, Mobile Home
P
REPARATION
Factory packaging must be removed, and some
minor assembly work is required prior to
installation and use. Access to the rear and sides of
the stove will be necessary at some point in time so
be sure to leave ample room for access, otherwise,
be prepared to move the stove when necessary.
Install the ceramic Brick Panel onto the rear
combustion wall. T
HIS IS A REQUIRED COMPONENT
Brick Panel is fragile, so handle with care at all
times. Your stove warranty only covers this item
from thermal breakage. Impact damage resulting from dropping or accidental abuse is not covered.
AUGER INSTALLATION: Install the auger into the auger tube as shown in Figure 2.
The flat face of the auger is toward the front of the stove, and the beveled edge will
go into the auger tube. Make sure the auger is all the way to the rear and is
engaged or seated properly.
. The
STIR ROD
the Burn Pot Holder with the fuel spreader towards the rear of the
stove, as shown.
Insert the stir rod into the burn pot with the beveled connector
toward the left. Align the beveled segments so that the holes on each
piece align, and insert the cotter pin.
& BURN POT INSTALLATION: The Burn Pot must be set into
Chapter 1 – Installation
Page 1