Installing An Rps Adapter; Removing An Rps Adapter - Cisco 2900 series Installation Manual

Chapter 5 Installing and Upgrading Internal Modules and FRUs
Table 5-3
Power Mode
2911 in POE
Boost
2921, 2951 in
POE Boost

Installing an RPS Adapter

To install an RPS adapter, perform the following steps:
Caution The RPS adapter must be in the router chassis before connecting to the RPS.
Step 1 Read the
perform any module replacement.
Step 2 Ensure AC or DC power is disconnected from the router power supply.
Step 3 If connected, place the RPS 2300 into standby mode. Consult the
Hardware Installation Guide
Step 4 If an RPS Adapter had never been installed, a blank panel is in its place. Remove the RPS Adapter blank
panel.
Insert the RPS adapter into the router
Step 5
Step 6 Connect the RPS 2300 cable into the RPS adapter connector.
Step 7 Connect the other end of the RPS 2300 cable to the RPS 2300.
Step 8 Power up the router.
Place the RPS into Active mode.
Step 9

Removing an RPS Adapter

To remove an RPS adapter, perform the following steps:
Read the
Step 1
replacement.
If connected, place the RPS 2300 into standby mode. Consult the
Step 2
Hardware Installation Guide
Power off and disconnect the AC or DC power from the router power supply.
Step 3
Remove the RPS cable from the RPS 2300.
Step 4
Remove the other end of the RPS 2300 cable from the RPS adapter.
Step 5
Remove the RPS adapter.
Step 6
OL-18712-03
RPS 2300 Backup Capabilities (continued)
Quantity 1
C3K-PWR-750WAC
0
0
"Safety Warnings" section on page 5-2
for operating the RPS 2300.
Safety Warnings section and disconnect the power supply before you perform any module
for operating the RPS 2300.
Replacing Power Supplies and Redundant Power Supplies
Quantity and Type of RPS 2300 FRU
Quantity 2 Quantity 1
C3K-PWR-750WAC C3K-PWR-1150WAC
1
1
section and disconnect the power supply before you
(Figure 5-29 or Figure 5-30) and tighten the screws.
Cisco 2900 Series and 3900 Series Hardware Installation Guide
Quantity 2
C3K-PWR-1150WAC
1
0
Cisco Redundant Power System 2300
Cisco Redundant Power System 2300
2
1
5-43