Cisco 2900 series Installation Manual page 151

Chapter 4 Configuring the Router
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
copy nvram:startup-config {ftp: | rcp: | tftp:}
Example:
Router# copy nvram:startup-config ftp:
Step 3
show {flash0|flash1}:
Example:
Router# show {flash0|flash1}:
Step 4
copy {flash0|flash1}: {ftp: | rcp: | tftp:}
Example:
Router# copy {flash0|flash1}: ftp:
Examples
Copying the Startup Configuration to a TFTP Server: Example
The following example shows the startup configuration being copied to a TFTP server:
Router# copy nvram:startup-config tftp:
Remote host[]? 172.16.101.101
Name of configuration file to write [rtr2-confg]? <cr>
Write file rtr2-confg on host 172.16.101.101?[confirm] <cr>
![OK]
Copying from Flash Memory to a TFTP Server: Example
The following example shows the use of the show {flash0|flash1}: command in privileged EXEC to
learn the name of the system image file and the use of the copy {flash0|flash1}: tftp: privileged EXEC
command to copy the system image (c3900-2is-mz) to a TFTP server. The router uses the default
username and password.
OL-18712-01
enable
copy nvram:startup-config {ftp: | rcp: | tftp:}
show {flash0|flash1}:
copy {flash0|flash1}: {ftp: | rcp: | tftp:}
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Copies the startup configuration file to a server.
The configuration file copy can serve as a backup copy.
•
Enter the destination URL when prompted.
•
Displays the layout and contents of a flash memory file
system.
Learn the name of the system image file.
•
Copies a file from flash memory to a server.
Copy the system image file to a server to serve as a
•
backup copy.
Enter the filename and destination URL when
•
prompted.
Cisco 2900 and 3900 Series Hardware Installation
Verifying Network Connectivity
4-23