Installing A Pvdm3 - Cisco 2900 series Installation Manual

Installing and Removing PVDM3
Figure 5-16
1
Place the PVDM3 in an antistatic bag to protect it from ESD damage.
Step 4

Installing a PVDM3

To install a PVDM3, follow these steps.
Fill PVDM3s slots sequentially, starting with connector 0.
Note
Read the
Step 1
perform any module replacement.
Locate the PVDM3 connector on the system board. See the
Step 2
page 5-7
Orient the PVDM3 so that the polarization notch lines up with the polarization key on the connector. See
Step 3
Figure
Cisco 2900 Series and 3900 Series Hardware Installation Guide
5-22
Removing a PVDM3
1
Pull away the retaining clips
"Safety Warnings" section on page 5-2
for the PVDM3 locations.
5-17.
Chapter 5 Installing and Upgrading Internal Modules and FRUs
2
2 Pull out the PVDM3
section and disconnect the power supply before you
"Locating Internal Modules" section on
1
OL-18712-03