Installing The 3G Adapter For Extended Cable/Antenna - Cisco 860 Series Hardware Installation Manual

Chapter 3 Connecting the Router
Step 8 Remove the protective tape from the adhesive on the bottom of the antenna cradle, then firmly press the
cradle to the flat surface.

Installing the 3G Adapter for Extended Cable/Antenna

For better signal and reception, if you are using the Cisco 3G Adapter for Extended Cable/Antenna,
3G-ACC-SMKTS9-TNC, follow these steps to install it:
Locate and remove the Phillips screw on the left side of the router as shown in
Step 1
screw aside for Step 4.
Figure 3-14
1
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-04
Locating the Phillips Screw
2
2
Phillips screw on the left side of router
Installing the 3G Adapter for Extended Cable/Antenna
1
2
Air vent holes to be aligned with adapter
Figure 3-14. Keep the
3-15