Verifying The Front Panel Led Indications; Performing The Initial Configuration On The Router; Using Cisco Setup Command Facility - Cisco 2900 series Installation Manual

Performing the Initial Configuration on the Router

Verifying the Front Panel LED Indications

The front-panel indicator LEDs described in
useful during power up.
Performing the Initial Configuration on the Router
Use the following tools to perform the initial configuration on the router:
•
•
•

Using Cisco Setup Command Facility

The setup command facility prompts you to enter the information that is needed to configure a router
quickly. The facility steps you through a initial configuration, including LAN and WAN interfaces. For
more general information about the setup command facility, see the following document:
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.4, Part 2: Cisco IOS User
Interfaces:Using AutoInstall and Setup:
http://www.cisco.com/en/US/docs/ios/fundamentals/configuration/guide/12_4/cf_12_4_book.html
This section explains how to configure a hostname for the router, set passwords, and configure an
interface for communication with the management network.
The messages that are displayed will vary based on your router model, the installed interface modules,
Note
and the software image. The following example and the user entries (in
only.
If you make a mistake while using the setup command facility, you can exit and run the setup command
Note
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (Router#).
Enter the setup command facility by using one of the following methods:
Step 1
•
Cisco 2900 and 3900 Series Hardware Installation
4-4
Using Cisco Setup Command Facility
Using Cisco Configuration Professional Express
Using Cisco IOS CLI—Manual Configuration
From the Cisco IOS CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
You are now in the Setup Configuration Utility.
The prompts in the setup command facility vary; depending on your router model, on the installed
interface modules, and on the software image. The following steps and the user entries (in bold) are
shown as examples only.
Table 1-13 provide power, activity, and status information
Chapter 4 Configuring the Router
) are shown as examples
bold
OL-18712-01