Installing A Fips Louver - Cisco 2900 series Installation Manual

Chapter 5 Installing and Upgrading Internal Modules and FRUs

Installing a FIPS Louver

A Federal Information Processing Standards (FIPS) louver can be installed to make a Cisco 2911 system
compliant with FIPS 140-2. Complete the following steps to install the louver.
Read the
Step 1
perform any module replacement.
Remove the screws to gain access to the side of the router as shown in
Step 2
Insert the four 8-32 screws through the FIPS louver plate, then position the FIPS spacers over the screws.
Step 3
See
Figure 5-40
1
3
Tighten the screws to secure the louver and spacers onto the router.
Step 4
Figure 5-41
OL-18712-03
"Safety Warnings" section on page 5-2
Figure 5-40.
FIPS Louver Components and Installation)
Screws
FIPS louver spacer
Properly Installed FIPS Louver
section and disconnect the power supply before you
Ci sc o 29
00 Se rie
s
3
2 FIPS louver
Ci sc o 29
00 Se rie
s
Cisco 2900 Series and 3900 Series Hardware Installation Guide
Installing a FIPS Louver
Figure 5-40.
3
1
1
2
5-51