Cisco 2900 series Installation Manual page 171

Chapter 5 Installing and Upgrading Internal Modules and FRUs
Figure 5-14
1 ISM
Caution Make sure that the standoffs are straight when installed. Tighten them gently but firmly. The shoulder
must be seated tightly against the system board.
Insert the connector on the ISM and attach it to the system board. See
Step 5
Note
Insert the screws from the accessory kit through the ISM into the standoffs. See
Step 6
tighten the screws with a Phillips screwdriver (torque 6 to 8 in-lb or 0.7 to 1.1 Nm.).
Check that the ISM is installed correctly on the system board. See
Step 7
Figure 5-15
Cisco 2900, See the
Step 8
or
Cisco 3900, See the
OL-18712-03
Connecting the ISM to the Cisco 2900 and 3900 Series System Board
2
Be sure to press firmly on the ISM until the board seats onto the connector.
Correctly Installed ISM
"Accessing Internal Modules" section on page
"Removing and Replacing the Services Performance Engine" section on page
1
2
2 Standoffs (4)
Cisco 2900 Series and 3900 Series Hardware Installation Guide
Installing and Removing ISMs
Figure 5-15.
Figure 5-13. Carefully
Figure 5-15.
5-4.
5-6.
5-19