Oce TDS750 User Manual page 374

Load cut sheet material
Note:
Make certain that the handle is properly aligned with the appropriate indicator.
[245] Adjust the position of the right-hand guide
Remove the packaging of the media. In case of wrapped paper, also remove the top and
3.
bottom sheets.
Note:
If you use polyester as media, you have to fan the sheets before you load them to prevent
them from sticking together.
Position the media in the drawer against the front plate. The side to be printed should
4.
be facing down.
Note:
You can check whether the material is properly loaded by looking through the view holes
in the drawer; see the illustration above.
Adjust the right-hand guide. Carefully place the media in the drawer to avoid damage to
5.
the media.
Slide the two other guides into position. Also refer to the sticker inside the drawer.
6.
Close the drawer.
7.
374 Chapter 10 - Maintain the Océ TDS750