Cycle Door; Table 3: Key To Symbols - Bosch GV2 Series Owner's Manual

GV2 Series Control Panels | Owner's Manual Supplement
7. The first sub-function that appears is CYCLE DOOR?. You can
cycle through the three sub-functions by pressing [PREV] and
[NEXT].
On a D1260 Keypad
1. Ensure that the display shows idle disarmed text.
2. Press the [COMMAND] key. The display shows SYSTEM
COMMAND.
3. Press [4] and [6].
You can use the function list in place of steps 2 and 3 to
start this function.
1. Press the [Menu>] soft key to enter the function list.
2. Press [Next>] repeatedly until you reach the DOOR
CTRL? prompt.
3. Press the [Door Control ? >] soft key.
4. All authorized door control function sub-functions are listed.
Press the corresponding soft key to enter the sub-function.
2.9.3

Cycle Door?

1. To unlock an access door briefly and allow a person into an
area, press [ENT] at the Cycle Door? prompt.
The display shows CYCLE 1 2 3 4 5 6 7 8 if all doors are in
a normal state and available. If a door is not in a normal state,
the number of the door is replaced with one of the symbols
indicated in Table 3.

Table 3: Key to Symbols

Symbol
---
C
U
X
P
Bosch Security Systems, Inc. | 2/07 | F01U063791-01
Description
Door is not active, not in scope, or user does not have
access level authority
Door is timed door sequence
Strike and shunt are latched active (held open)
Strike and shunt are deactivated (secured)
There is a problem with the door; call your security
company
15