Table of Contents
Advertisement
GV2 Series Control Panels | Owner's Manual Supplement
4. Press the [ENT] key to activate the selected walk test function.
The keypad shows the number of testable points within the
scope of the keypad: ### PTS TO TEST
5. Press the [NEXT] key to see VIEW UNTESTED?
6. Press the [ENT] key to view the untested points. The keypad
shows the total number of untested points within the keypad
scope: ### PTS UNTESTED.
7. Press the [NEXT] key to view the first point's name.
8. Press the [ENT] key to view the point's hardware state. Refer
to Table 2.
Table 2:
Hardware States of Points
Display Text
1PT### NORMAL HW
1PT### OPEN HW
1PT### SHORT HW
1PT### MISSNG HW
9. Activate the point's sensor and observe the appropriate state
change.
10. Press the [NEXT] key to advance to the next untested point
within the scope of the keypad.
11. Repeat steps 8 through 10 until all points are tested.
On a D1260 Keypad:
1. If you use the command sequence, press the keys indicated in
the Command Sequence column of Table 1 on page 10 for the
necessary walk test. The keypad shows the number of testable
points within the scope of the keypad: ### points remain
to be tested. Proceed to Step 5.
2. If you use the menu function list, press the [Menu>] soft key in
the lower right corner.
3. Press the [Next >] soft key until the Menu Function Name
(refer to Table 1 on page 10) appears.
4. Press the corresponding soft key to activate the necessary
Walk Test functions.
The keypad shows the number of testable points within the
scope of the keypad: ### points remain to be tested.
Bosch Security Systems, Inc. | 2/07 | F01U063791-01
Hardware State
Normal
Opened
Shorted
Missing
11
Advertisement
Table of Contents
