Denon DVD-3800 Operating Instructions Manual page 15

(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See page 33.)
• "DIGITAL OUT" "PCM"
"LPCM (44.1kHz/48kHz)"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-3800
COMPONENT
VIDEO OUT
VIDEO OUT S-VIDEO OUT
Y
1 P /C 1
B B
2 P /C 2
R R
SL C FL2 FL1 COAXIAL
SR SW FR2 FR1
DIGITAL OUT
AUDIO OUT
(PCM / BIT STREAM)
(6) Connecting to a Stereo Component
DVD-3800
COMPONENT
VIDEO OUT
VIDEO OUT S-VIDEO OUT
Y
1 P /C 1
B B
2 P /C 2
R R
SL C FL2 FL1 COAXIAL
SR SW FR2 FR1
DIGITAL OUT
AUDIO OUT
(PCM / BIT STREAM)
NOTES:
When connecting to a 2-channel audio stereo device, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "2
•
CHANNEL" (see page 30). For multi-channel sources, the signals are down-mixed into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
• Set "LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP" at "SETUP" to "OFF". (See page 33.)
(If set to "ON", analog audio signals converted to 48 kHz or less will be output for linear PCM or packed PCM sources.)
Set "DIGITAL OUTPUT" at "PURE DIRECT MODE" to "OFF". (See page 43.)
•
(If set to "ON", analog audio signals converted to 96 kHz/88.2 kHz will be output when playing sources recorded at 196 kHz/176.4 kHz.)
"ON"
OPTICAL
75 /ohms pin-plug cable (commercially available)
OPTICAL
REMOTE CONTROL
RS-232C ROOM TO ROOM
IN OUT
input connector
Optical fiber cable (commercially available)
Stereo component
B
Digital audio Digital audio
input connector
(COAXIAL) (OPTICAL)
ENGLISH
8 9
15