ProForm 470 Hr Elliptical User Manual page 6

4. The Console (22) requires four "AA" batteries; alka-
line batteries are recommended. Remove the bat-
tery cover from the back of the Console and insert
four batteries into the Console; make sure that the
batteries are oriented as shown by the diagram
inside the Console. Then, reattach the battery
cover.
5. While another person holds the Console (22) near
the top of the Upright (3), connect the console wire
to the Upper Wire (75). Then, connect the lower
wire on the back of the console to the upper wire on
the back of the console.
Attach the Console (22) to the Upright (3) with four
Console Screws (68). Be careful to avoid pinch-
ing the wires.
Note: If you have purchased the optional pulse sen-
sor (see page 19 for more information), disregard
the instructions for installing the receiver. The con-
sole on this elliptical exerciser already has a receiv-
er installed.
6. Identify the Right Pedal (63), which has an "R"
molded into its bottom surface, and the Right Pedal
Tube (64), which is marked with a sticker.
Attach the Right Pedal (63) to the Right Pedal
Tube (64) with two M8 x 1 9/16" Hex Bolts (41), two
M8 Washers (52), and two M8 Nylon Locknuts (57).
Attach the Left Pedal (8) to the Left Pedal Tube
(4) in the same way.
4
22
5
Console Wire
Avoid pinching
the wires during
this step
6
8
6
Battery Cover
Batteries
22
75
68
3
41
4
63
64
52
57
52