Billion BiPAC 7300N User Manual page 57

no one will be able to locate the Access Point (AP) of your router.
Disable: When Disable is selected, you can allow anybody with a wireless client to
be able to locate the Access Point (AP) of your router.
Regulation Domain: There are seven Regulation Domains for you to choose from,
including North America (N.America), Europe, France, etc. The Channel ID will be
different based on this setting.
Channel ID: Select the ID channel that you would like to use.
Channel Wdith: Select either 20 MHz or 20/40 MHz for the channel bandwidth. The
higher the bandwidth the better the performance will be.
Tx Power Level: It is function that enhances the wireless transmitting signal strength.
User may adjust this power level from minimum 0 up to maximum 100.
Note: The Power Level maybe different in each access network user premises environment
and choose the most suitable level for your network.
AP MAC Address: It is a unique hardware address of the Access Point.
AP Firmware Version: The Access Point firmware version.
WPS service: Enable / disable
WPS State: Current WPS state in AP. It is be used for WCN (Windows Connect Now).
Configured: This AP is be configured via WPS. It is not allowed to configure via
WCN.
Unconfigured: This AP is un-configured via WPS. It can be configured via WCN.
WMM: This feature works concurrently with QoS that enables the system to prioritize the
flow of data packets according to 4 categories: Voice, Video, Best Efforts and Background.
Enable: Check to activate WMM feature.
Disable: Check to deactivate WMM feature.
Wireless Distribution System (WDS)
It is a wireless access point mode that enables wireless link and communication with other
access point. It is easy to be installed, simply define the peer's MAC address of the
connected AP. WDS takes advantages of cost saving and flexibility which no extra wireless
client device is required to bridge between two access points and extending an existing
wired or wireless infrastructure network to create a larger network.
WDS Service: The default setting is Disable. Check Enable radio button to activate this
function.
1. Peer WDS MAC Address: It is the associated AP's MAC Address. It is important that
your peer's AP must include your MAC address in order to acknowledge and
communicate with each other.
54