Cm (Change Command Mode) - NEC Express5800 1160Xd User Manual

CM (Change Command Mode)

This command changes the command mode from Normal mode to Maintenance mode.
Entering Maintenance mode requires the entry of a password.
Screen Image
iSPyz:---> cm<ENTER>
Password is needed to enter maintenance mode.
maintenance password : xxxxxxxx <ENTER>
incorrect.
maintenance password : xxxxxxxx <ENTER>
Command Mode was changed to maintenance mode.
Reference
A
B
3-18 Service Processor
Table 3-19. CM Command Screen
Table 3-20. CM Screen References
Description
To switch from Normal mode to Maintenance mode, a password is required.
If you enter a wrong password, a message is displayed and the system waits for
another password entry. If you enter an incorrect password three times in a row, the
command terminates.
Passwords are case sensitive.
After the mode change to Maintenance mode is displayed, the command terminates.
NML MNT m
X X X
b u
X X
Reference
A
B