NEC Express5800 1160Xd User Manual page 103

Table 3-36. HC State Display Strings (cont'd)
Displayed String Description
backup This is valid only for the state display of the ISP Board/CLK Board. Indicates that
it is operating as the backup.
enable Indicates that the component itself is enabled (used for system operation).
DISABLE Indicates that the component itself is disabled (not used for system operation).
In this state, it is detached from the system manually with the "disable"
command.
DISABLE* Indicates that the component itself is disabled (not used for system operation).
In this state, it is detached from the system due to failure of the component itself
or failure of the host interface.
It should not be configured in the system until the defective part is replaced.
DEG Indicates that some subcomponents are in the DISABLE state.
Screen Image
iSPyz:---> hcENTER>
iSP FW version is Rxx.xx.
HC> help<ENTER>
HC command help :
help : print this message.
disp : display current status.
smem : set size of shared memory of a partition.
attach : attach CELLs and IORs to a partition.
detach : detach CELLs and IORs from a partition.
swap : swap CELLs in a partition.
add : add a component.
delete : delete a component.
enable : enable a component.
disable : disable a component.
online : make a component online.
offline : make a component offline.
ncconn : connect 1.6G ports each other.
ncdis : disconnect 1.6G ports.
led : turn on/off maintenance LED of a component.
loc : set location info.
clear : clear memory bit error counters.
check : check illegal configuration.
quit : quit from HC command prompt.
A: Displays Help for the HC command when you enter "help".
B: Displays the list of HC commands.
Table 3-37. HC Help Screen
Reference
A
B
Service Processor 3-47