Up (Bring Up System) - NEC Express5800 1160Xd User Manual

UP (Bring Up System)

This command turns on the power (DC) of the system, initializes the hardware, and then
starts up the BIOS.
Whether the operating system starts up depends on the BIOS/EFI settings.
Note:
Maintenance mode.
Screen Image
iSPyz:---> upENTER>
This command will bring up the specified partition.
Enter partition number (0-3/all/CR=exit) : all<ENTER>
Execute OK? (y/[n]) y<ENTER>
UP command was accepted. All partitions will run soon.
[iSPyz:INFO.ccc] partition 0 : power on sequence started.
[iSPyz:INFO.ccc] partition 1 : power on sequence started.
:
[iSPyz:INFO.ccc] partition 1 : power on sequence completed normally.
:
[iSPys:INFO.ccc] partition 1 : handed off the control to BIOS.
Reference
A
B
C
D
The UP command can be executed in Normal mode or
Table 3-47. UP Display Screen
Table 3-48. RS Display Screen References
Description
Enter a partition number
If you select "all", all the configured partitions become the targets.
Displays the confirmation message.
To execute, enter "y."
Displays the UP command acceptance message.
The actual process runs in the background.
Displays the state of the process running in the background.
NML MNT m
X X X
Service Processor 3-57
b u
Reference
A
B
C
D