NEC Express5800 1160Xd User Manual page 96

cmd arg1
enable xbcx
(cont'd)
3-40 Service Processor
Table 3-35 HC Subcommands (cont'd)
arg2 arg3 arg4
[all] - -
cxix
- -
ncix
- -
moverx - -
Description
Enables the XBC Board.
"x" is the XBC Board physical number (0-3).
When the second argument is omitted, only the
XBC Board is enabled, and the states of any
other subcomponents do not change.
When "all" is specified as the second argument,
not only the XBC Board but also its
subcomponents become enabled.
Enables the CELL Board interface part within
the XBC Board.
"x" is the interface part number (0-3).
For XBC Board 0 and XBC Board 1:
0: Corresponds to CELL Board 0
1: Corresponds to CELL Board 1
2: Corresponds to CELL Board 2
3: Corresponds to CELL Board 3
For XBC Board 2 and XBC Board 3:
0: Corresponds to CELL Board 4
1: Corresponds to CELL Board 5
2: Corresponds to CELL Board 6
3: Corresponds to CELL Board 7
It coordinates with the interface part in the
opposing CELL Board side.
Enables the NC1/NC2 Board interface part
within the XBC Board.
"x" is the interface number (0-3).
0: 1.6G cable port 0
1: 1.6G cable port 1
2: XBC Board-XBC Board connection or free
3: XBC Board-XBC Board connection or free
When the No. 2 interface is enabled by nci2, the
No. 3 interface is automatically enabled (the
opposite is the same).
Also, when the No. 2 interface is disabled by
nci2, the No. 3 interface is automatically
disabled (the opposite is the same).
The interface within the connected XBC Board
is enabled or disabled simultaneously.
Enables the MOVER part within the XBC Board.
"x" is the mover number (0-1).