NEC Express5800 1160Xd User Manual page 97

Table 3-35 HC Subcommands (cont'd)
cmd arg1 arg2
enable cellx [all]
(cont'd)
cxiy
procxy -
mmcxy
[all]
rowz
arg3 arg4 Description
- - Enables the CELL Board.
"x" is the physical CELL Board number (0-7).
When the second argument is omitted, only the
CELL Board is enabled, and the states of any
other subcomponents do not change. In this
case, operation is rejected if some required
components are disabled.
When "all" is specified as the second argument,
not only the CELL Board but also its
subcomponents become enabled.
- - Enables the XBC interface part within the CELL
Board.
"y" is the interface part number (0-1).
For CELL Board 0-3:
0: Corresponds to XBC Board 0
1: Corresponds to XBC Board 1
For CELL Board 4-7:
0: Corresponds to XBC Board 2
1: Corresponds to XBC Board 3
It coordinates with the interface part in the
opposing XBC Board.
- - Enables the Processor.
"x" is the physical CELL Board number (0-7).
"y" is the Processor number (0-3) within the
CELL Board .
- - Enables the MMC.
"x" is the physical CELL Board number (0-7).
"y" is the MMC number (0-1) within the CELL
Board.
When the second argument is omitted, only the
MMC is enabled, and the states of any other
subcomponents do not change.
When "all" is specified as the second argument,
not only the MMC but also its subcomponents
become enabled.
- - Enables the ROW.
"z" is the ROW number (0-7).
DIMM is not controlled individually.
DIMMs are automatically detected at the time of
startup.
Service Processor 3-41