NEC Express5800 1160Xd User Manual page 91

Table 3-35 HC Subcommands (cont'd)
cmd arg1 arg2
mmcxy
disp -
(cont'd)
tagx -
xbcx -
pcixx -
pbayxy
-
attach - -
cellx n
arg3 arg4 Description
- -
Displays the detailed state of the ROW under
control of the MMC specified by "xy".
"x" is the physical CELL Board number (0-7) on
which MMC is installed.
"y" is the MMC number (0-1) in the CELL Board.
- -
Displays the detailed state of the TAG.
"x" is the physical CELL Board number (0-7) on
which TAG is installed.
- -
Displays the state of the XBC Board.
"x" is the physical XBC Board number (0-3).
- - Displays the state of the PCIX Unit.
"x" is the DGI/I2C cable port number (0-7) from
the iSP to the PCIX Unit.
- - Displays the state of the Power Bay Unit.
"x" is the cabinet number.
0: Main Cabinet
1: I/O Expansion Cabinet
"y" is the ID number within the cabinet.
0-2 in the Main Cabinet
0-1 in the I/O Expansion Cabinet
- - Used to associate partition numbers to CELL
Boards and IOR Daughter Boards.
The number of CELL Boards in a partition must
be greater than the number of IOR Daughter
Boards.
Displays Help for "attach" when the argument is
omitted or an error is made.
m
- Associates the CELL Board having the physical
number x with the logical CELL Board number
m of partition n. (m: The number recognizable
by the BIOS and software.)
This command can also be used to change a
logical CELL Board number if it has already
been associated.
Each logical CELL Board number must be
unique among the 8 CELL Boards.
You cannot change the logical number of the
CELL Board in the online state.
Service Processor 3-35