Cm (Change Command Mode) - NEC 1080Xd User Manual

CM (Change Command Mode)

Execution:
This command can be executed in the AC POWER ON state or DC POWER ON state.
Entering Maintenance mode requires the entry of a password.
Function:
Changes from Normal mode to Maintenance mode. When the system is in Maintenance
mode, the Status LED on the front of the server is amber.
Note:
Maintenance mode.
Screen Image
iSPyz:---> cm<ENTER>
Password is needed to enter maintenance mode.
maintenance password : xxxxxxxx <ENTER>
incorrect.
maintenance password : xxxxxxxx <ENTER>
Command Mode was changed to maintenance mode.
Reference
A
B
The CM command can be executed in Normal mode or
Table 3-19. CM Command Screen
Table 3-20. CM Screen References
Description
To switch from Normal mode to Maintenance mode, a password is required.
If you enter a wrong password, a message is displayed and the system waits for
another password entry. If you enter an incorrect password three times in a row, the
command terminates.
Passwords are case sensitive.
After the mode change to Maintenance mode is displayed, the command terminates.
Reference
A
B
Service Processor 3-17